![]() Either the Source or the DestinatioFileType have to be set to startupConfig or runningConfig. TFTP is defaultĭescripton: Defines the source. CISCO-CONFIG-COPY-MIB.oid functionsĭescription: Defines whicn protocol is used for the copy process. The following section describes all CISCO-CONFIG-COPY-MIB functions so you can change the process how you like it. Just to keep it easy and the same way I always use 111. The number 111 at each OIDs end is nothing else then a randomly picket number which has to be the same during the whole copy process. Sets the CopyStatus to delete which cleans all saved informations out of the MIB Sets the CopyStatus to active which starts the copy process. Sets the CopyFilename to your desired file name. Sets the ServerAddress to the IP address of the TFTP server Set the DestinationFileType to networkfile Please remember to use the ReadWrite Community for your devices. The shown command line syntax was taken from NET-SMP 5.4.1. You need SNMP Write Access at the device and a device where you can use the snmpset command. ![]() This is a step by step guide on how to save the running-config on a TFTP Server. If you also know your way around scripting (Shell, Perl or whatever you prefer) this is how you could save your devices automatic. Saving the configurations from Cisco Devices is normally done by a tool (CW2k, Solarwinds Cirrus or whatever) but if you do not want to buy a tool here’s a way to do it yourself.Ĭisco has a SNMP MIB called CISCO-CONFIG-COPY-MIB.oid which allows to save the configurations from Cisco devices over SNMP. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |